Underpinning Brackets

Standard-Duty Underpinning Brackets for Helical Pile Foundation System

For use with 1 1/2″ and 1 3/4″ square shaft anchors, as specified below, each bracket is identified by the size stamped on the vertical gusset. Brackets also may be used in conjunction with Uplift-Restraint Bracket.

Bracket comes complete with the hardware required for assembly of bracket; does not include concrete anchor bolts.

The lifting assembly, consisting of the underpinning bracket and jacking tool, is designed to lift with hydraulic jack assist as shown below. However, if jack assist is not available, lifting can be done with the bolts of the bracket. The recommended method is to use a hydraulic jack with a load gauge to avoid exceeding the ratings of the brackets.

C150-0121
C150-0121_Assembly

Installation Tool

NOTE: Hydraulic jack not furnished

Jacking Tool
C150-0117
Jacking Tool
assembled to bracket
jack_tool jack_tool_assembly

Dimensions affecting size of hydraulic jack

Clearance between two flat washers 4 3/4″
Clearance between bolt couplings 5″
Maximum compressed height of jack 11″